Ika RC 2 basic User Manual download pdf (Page 10)

Before commissioning, make sure

that the device has not been moved

for one hour.

Check whether the voltage specied on the type plate

matches the mains voltage available.

The power socket used must be

earthed (protective earthing).

If above conditions are met, the instrument is ready for

operation after plugging in the mains plug.

If these conditions are not met, safe operation is not guar-

anteed and the device could be damaged.

Observe the ambient conditions (temperature, humidity,

etc.) listed under “Technical Data”.

After switching on the mains switch (2) at the back of the

device or pressing the ON/OFF key (A), all LED segments light

up during the self test.

Commissioning









After that, following two screens appear alternately.

Display ﬁeld

Software version (ver)

Operating mode (mode)

Working setting



Then the device enters standby status and is ready for

operation.

Change the temperature setting with “Temp (+)“ button

Change the pump speed setting with “Pump (+)“ button

(F) or “Pump (-)“ button (G).

In standby status, activate the refrigerating function by

pressing the “Temp“ button (B). The pump and fan starts

to run at once. The refrigerating function may delay to

start at maximum 2 minutes.

In working status, press the “OK/Pump“ button (E) to

stop the pump function. The refrigerating function and

pump stops.

Note: In running status, the pump speed adjusts auto-

matically according to the load. When the actual speed

doesn’t reach the setting speed, the actual speed and set-

ting speed will appear on the screen alternately.

In standby status, press the “OK/Pump“ button (E) to

start the pump function. The refrigerating function will

not be activated.

In working status, press the “Temp“ button (B) to stop

the refrigerating function, the pump keep running.

The controls of the device allow to be locked by pressing

the key button (I), so no accidental changes during opera-

tion are possible (LED (J) lights up).

By pressing the key button (I) again, the controls are re-

leased (LED (J) no longer lights up).



NOTICE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Comments to this Manuals

No comments

Ika RC 2 basic User Manual Page 10

Comments to this Manuals

Related products and manuals for Equipment Ika RC 2 basic