Ika RT 15 power IKAMAG User Manual download pdf (Page 8)

Power

RT 10 power

IKA WE

RKE

Mot

Temp

Power

RO 10 power

ERKE

Mot

Please unpack the equipment carefully and check for any dama-

ges. It is important that any damages which may have arisen

during transport are ascertained when unpacking. If applicable a

fact report must be set immediately (post, rail or forwarder).

The delivery scope covers: an IKAMAG RO 5, 10 or 15 power and

operating instructions bzw.an IKAMAG RT 5, 10 or 15 power and

operating instructions.

Check whether the voltage specified on the type plate matches

the mains voltage available. The power socket used must be ear-

thed (protective earth conductor contact). If these conditions are

met, the device is ready to operate after plugging in the mains

plug. If these procedures are not followed, safe operation cannot

be guaranteed and/or the equipment may be damaged.

Observe the ambient conditions (temperature, humidity, etc.)

listed under Technical Data.

The device is switched ON/OFF by means of the appliance switch (A) loca-

ted on the right. The LED for "Power" (B) becomes green when the switch

is activated.

The speed of the motor is set on the control knob ”Mot”

from 1 to 10 (D), which roughly corresponds to a range from 0 to 1200

rpm. The maximum speed of 1200 rpm is obtained when the control knob

is turned all the way to the right in no-load operation.

If the viscosity of the medium increases during processing, then the speed

drops slightly. If the viscosity decreases, e.g. due to the addition of low-

viscosity media, then the speed

rises slightly. In eit-

her case

the

control

knob

can be

adjusted

to com

pensate

for this

speed change, provi-

ded the required torque does not exceed the maximum torque.

Note that fluctuations in the mains voltage within the permissible toleran-

ces will also result in slight variations in speed.

The device is switched ON/OFF by means of the appliance switch

(A) loca-

ted on the right. The LED for "Power" (B) becomes green when the switch

is activated.

The temperature of the heater plate can be adjusted on the „Temp“ turn

dial (E) with the corresponding scale from 1 to 10 (F).

If energy is being directed to the heater plate, the „Temp“ LED (G) lights

up yellow. The scale values 1 through

10 correspond to

temperatures

on the

surface

from

0°C

trough

120°C.

RO/RT 0205

Function Stirring

Unpacking

Commisioning

Function Heating

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Ika RT 15 power IKAMAG User Manual Page 8

Comments to this Manuals

Related products and manuals for Equipment Ika RT 15 power IKAMAG